ISO 9001 Registered | Member: NFPA and FPDA  |   |   |   | 
 |   |   |   |   |   |   | 
You searched for safety valve

Results 1 to 15 of 112
Search result

OSHA Requirements Clearly State, “Energy Isolating Devices, Such As Lockouts, Are Now Required.”


Federal regulation 29 CFR 1910.147 of the Occupational Safety and Health Administration (OSHA) details safety requirements for the control of hazardous energy during “… theservicing and maintenance of machines and equipment in which the unexpected … startup … could cause injury …” Here are a few other highlights from the regulation:


ENERGY SOURCE. “Any source of electrical, mechanical,hydraulic, pneumatic, thermal, or other energy.”


LOCKOUT DEVICE. “A device that utilizes a positive means such as a lock, whether key or combination, to hold an energy isolating device in the safe position …”


PURPOSE. “This section requires employers to establish a program and utilize procedures for affixing appropriate lockout devices . . . to prevent unexpected energization, startup or release of stored energy …”


TIMING. “After October 31, 1989, whenever major replacement, repair, renovation or modification of machines or equipment are installed, energy isolating devices for such machines or equipment shall be designed to accept a lockout device.”


In short, each piece of equipment must have a shutoff valve to isolate the equipment from its air supply. The shutoff valve must be lockable in the closed position so that it cannot inadvertently be opened. When closed the shutoff valve must have an exhaust port to exhaust downstream pressurized air.


Lockout Valves


Lockout valves are offered in a full range of port sizes, and with different actuation modes.  Each valve is designed to satisfy the OSHA requirements for energy isolation and lockout. They are not, however, intended as emergency stop devices. They lock out the supply air in a system with an easy pushing or sliding motion, and also e x h a u s t d own stream air pressure. Even after extended periods on standby, the valves are designed with seals and materials that allow the lockout control to move smoothly into the lockout position. All Master Pneumatic lockout valves can be secured in the closed position by means of a padlock so that the valve cannot be inadvertently opened to cause a potentially hazardous situation. Shown above is one of the manual lockout valves padlocked in the closed position.

Lockout Valves Overview Catalog Pages (290 KB)
Search result
Search result

The integration of a general purpose filter and a pressure regulator into a single module provides the compactness needed where space is limited. These integral filter/regulators are offered by Master Pneumatic in port sizes from 1/8" up to 3/4" along with SENTRY models equipped with quick-connect fittings for tubing from 1/4" up to 10 mm.


When an integral filter/regulator is paired with a lubricator, joined either by a modular connector or a pipe nipple, the assembly makes a complete FRL with nothing lost in performance, but with the advantage of compactness to fit in tight spaces.


All filter/regulators include an internal automatic filter drain and a pressure gauge as standard equipment, and regulators are either self-relieving or non-relieving. SENTRY, GUARDSMAN, and SERIES 380 assemblies include a lockout valve for added safety.


Available options are the same as those for the corresponding individual filters, regulators, and lubricators. They include regulating springs for various pressure ranges, metal filter bowls, and sintered bronze filter elements in several µm ratings, as well as quick-fill caps for the lubricators. All assemblies, except Miniatures, now include a lockout valve for increased safety.

Search result
Search result
Search result
Search result
Search result
Search result
Search result
Search result
Search result
Search result
Search result
© 2018 Master Pneumatic, Inc., Privacy Policy, Legal Statement